Installation Guide

How To Install?

Step #1 : Remove your existing showerhead

Unscrew your showerhead by turning it counterclockwise. If it’s tight, use a cloth for better grip.

Step # 2 : Attach the shower filter

Screw the filter onto the shower arm by hand. Make sure it’s snug but don’t overtighten.

Step # 3 : Reattach the showerhead

Now, screw your showerhead onto the filter’s outlet and tighten it by hand.

Step # 4 : Turn on the water

Run the shower for a minute to flush the filter and check for leaks. If you see any, tighten slightly.

Step # 1 : Turn Off the Water Supply

Switch off the shower to stop water flow. This prevents leaks while installing the cartridge.

Step # 2 : Remove the Showerhead

Unscrew your showerhead from the shower arm by turning it counterclockwise.

Step # 3 : Insert the New Cartridge

Open the filter housing and place the new cartridge inside. Make sure it fits securely.

Step # 4 : Reattach the Showerhead

Screw the showerhead back onto the filter or shower arm. Hand-tighten until snug.

Step # 5 : Run Water to Test

Turn on the shower and let water flow for a few seconds to check for leaks and ensure the cartridge is working properly.